Stenter Machine Used for Woven and Knitting Fabric

This stenter suits for weight arrange 50-700g/m2 cotton wool ,liner ,silk ,polyester ,fiber ect . Knitted or woven fabrics auxiliaries padding ,stentering ,drying and heat setting

Send Inquiry

Stenter machine used for woven and knitting fabric

Application：

This stenter suits for weight arrange 50-700g/m2 cotton wool ,liner ,silk ,polyester ,fiber ect . Knitted or woven fabrics auxiliaries padding ,stentering ,drying and heat setting .

Machine parameter :

Machine Mode	TPYD2800
Application	Open width fabric （70-400gsm）made of cotton ， Cotton/Polyester wool synthtic fiber and other blend fabric
Stenter type	Hot air circulation
Holding type	Pin+Clip
Rial type	SS stainless steel
Working speed	0-100m/min
Chamber length	3000mm
Chain type	Pitch 60mm Oil -free lubrication
Chamber no	2-10Chambers
Insulating board thickness	150mm
Temperature of chamber	100-220Degree
Overfeeding rate	-20-40%
Temperature	Adjustable separately
Control power supply	380V/50HZ /3Phase
Machine weight	40Ton
Compressed Air	0.3-0.6Mpa
Steam consumption	100-150Kg/h
Standard configuration	Single padder /Schneider component /ABB motors/Touch screen/Inverter/Maxson gas burner

Stenter Flow Procedure :

Flat feed cloth →High position guide cloth→Infrared expansion alignment device →two roll skew rolling mill (heavy duty )→Tension controller →Circular warping (active)→Infrared expansion alignment device →Lower feeding →Expanding roll→Electric weft →Upper overfeed→Four finger stripping →Infrared edge detection →Upper needle →heat setting chamber →Cold air cooling →Plaiting .

Machine drawing :

image001(001)

Machine features :

Fabric feed-in combinations

The basic structure of fabric feed-in combinations is composed of fabric feed-in frame ,expanding centering device ,padder ,speed synchronizing device and photoelectric weft straightening device ( Optional ) The effect of these combination is fabrics after expanded centered under low tension .Passed padder and exturded water ,added auxiliaries and through speed synchronizing device precisely controlled its tension between padder and photoelectric weft straightening device can effectively correct deformation weft arcs and skews from previous processing steps meet all kinds of process requirements before pinning .

image003(001)

Padder

Maximum output pressure is 10 tons ,Rubber wheel can be placed inclined or horizontal it has liquid adding , water and dye liquor extrusion functions ,Achieves the right evenness of padding liquid .Low residual shrinkage ,Liquid tank pneumatic lifting and dumping ,rapidly discharge .

image005(001)